Saturday, November 19, 2011

How to Remove Voltage Regulator on Car?


If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.


The procedure is as follows :----

Voltage Regulator


REMOVAL & INSTALLATION


Click image to see an enlarged view
Fig. To remove the voltage regulator, simply remove the two mounting screws . . .


Click image to see an enlarged view
Fig. . . . and carefully remove it from the alternator


Click image to see an enlarged view
Fig. Checking the alternators carbon brushes for wear
The voltage regulator is attached to the rear of the alternator and includes the brushes. Since no adjustment can be performed on the regulator, it is serviced only by replacement.
  1. Note the radio code, and then disconnect the negative battery cable.
  2. If the back of the alternator is not easily accessible, remove the alternator as necessary.
  3. If equipped, remove the cover on the back of the alternator.
  4. It is not necessary to disconnect any wiring. Remove the mounting screws and remove the regulator.
  5. Measure the free length of the brushes. If they are less than about 3 / 16 inch (5mm) long, the regulator must be replaced. New brushes are 1 / 2 inch (12mm) long.
  6. Install the new regulator and tighten the screws.
  7. The balance of assembly is in reverse order of removal.
------------
This details will help.
Thanks.

------------------
For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


----------

1 comment:

  1. Hello, I love reading through your blog, I wanted to leave a little comment to support you and wish you a good continuation. Wish you best of luck for all your best efforts. AC wall mounted voltage stabilizer, servo voltage controller stabilizers.

    ReplyDelete